Preventive Maintenance Program - BIESSE Ergho

Service	Cost
Flat rate for 2 days (includes 16 labor hours)	$1000.00 (per visit)
Any day after the 2nd day	$600.00 (per visit)

Additional Cost	Cost
Meals	$35.00/day
Travel hours	Actual (per visit)
Expenses (Airfare, car, lodging, etc.)	Actual (per visit)

This will include a general tune-up the machine, making sure everything is working well, and recommending any parts to be changed (see checklist below).

It will not include any repair/additional training on the machine not listed in the checklist. If repair/additional training is necessary it will require a different purchase order from the customer and the regular rates will apply.

It is Biesse Group America’s discretion (depending on the technician’s schedule and on the spare parts availability) to decide if the repairs can be done at the same time of the preventive maintenance.

The program includes two (2) visits per year. The customer and Biesse Group America will come to an agreement on what time of the year is best for both to schedule preventive maintenance. BIESSE AMERICA reserves the right to schedule the visit within 14 days of the customer’s request.

Once the schedule has been established, Biesse will contact you a month before so that we can schedule a PM maintenance.

Below is a list of items that will be checked on your POLYMAC

Machine & outrigger support level
Calibration of pressure rollers
Calibration of end trimming unit
Calibration beveling units
Calibration of glue scrapers
Condition of buffer pads
Check condition of feeding track pads
Tightness of all mounting hardware for units and motors
Limit switches and sensors: position and tightness
Encoder mounting elements
Gluepot condition
Glue roller lubrication
Gearbox lubrication
Bevel gear condition inside gearbox
End trim blades and all cutter inserts
Setting of all air pressure regulators
Bypassing of sound hood interlocks (Un-bypass and notify customer)
Main air lubricator (one drop every twenty cycles)
Make hard copy of all parameters in F3
Setting alarm set point on both thermo-regulators
Condition of heating elements and thermocouples
Clean out gluepot and lubricate the bearing