Preventive Maintenance Program - BIESSE Techno

Service	Cost
Flat rate for 2 days (includes 16 labor hours)	$1000.00 (per visit)
Any day after the 2nd day	$600.00 (per visit)

Additional Cost	Cost
Meals	$35.00/day
Travel hours	Actual (per visit)
Expenses (Airfare, car, lodging, etc.)	Actual (per visit)

This will include a general tune-up the machine, making sure everything is working well, and recommending any parts to be changed (see checklist below).

It will not include any repair/additional training on the machine not listed in the checklist. If repair/additional training is necessary it will require a different purchase order from the customer and the regular rates will apply.

It is Biesse Group America’s discretion (depending on the technician’s schedule and on the spare parts availability) to decide if the repairs can be done at the same time of the preventive maintenance.

The program includes two (2) visits per year. The customer and Biesse Group America will come to an agreement on what time of the year is best for both to schedule preventive maintenance. BIESSE AMERICA reserves the right to schedule the visit within 14 days of the customer’s request.

Once the schedule has been established, Biesse will contact you a month before so that we can schedule a PM maintenance.

Below is a list of items that will be checked on your TECHNO

Machine level
Calibration of X-axis for Rt. Horizontal, Lower Vertical and Upper Vertical
Calibration of Y-axis for Lt. & Rt. Horizontal (if equipped), Lower & Upper Verticals
Calibration of Z-axis of Lt. & Rt. Horizontal
Calibration of Backstops
Drilling head lubrication and general conditions
Check condition of belts, spindles, way bar scrapers, and millimeter counters
Setting of front pusher and right side pusher air regulators
Backstop micro-switches
Boring unit movement: Lt. & Rt. Horizontal, Upper & Lower verticals
Panel support level
Safety cable switches
Infeed/outfeed motors
Overturning clamps
End-cycle micro-switch inside boring units
Dust Augers and covers
Auto-lube system
Hydraulic braking units
Dowel Bowl Vibrators (SVBL/J & InforTechno)
Dowel Injectors (SVBL/J & InforTechno)
Glue Tanks & Distribution System
Version of EPROM
Reset axes on controller (if necessary)
Make backup hard copy of all data (axis data, timers, I/O, machine. configuration)